Location: Home > News > Dynamo Overheat of Charcoal Briquetting Machine

Dynamo Overheat of Charcoal Briquetting Machine

Improving the heat emission condition of dynamo is one of the solutions to deal overheat. If you feel the strong heat or hear the noise from working dynamo, you should immediately turn off the charcoal briquette machine and check the failure. Usually, there are three reasons that you can blame. As long as you check them one by one, charcoal briquette press machine can still work as normal.

charcoal briquettes making machine

If load on dynamo is heavy, it will be overheated. Supposing that the radiating situation is poor, it is normal for dynamo to be heated. If coal powders are too dry, charcoal briquette machine will have to be more laborious. If so, dynamo will be overheated. To deal the too-dry problem, you can add a little of water inside. Remember, the water addition should be as little as possible.

Before launching the charcoal briquetting machine, you should firstly clean the foreign materials around, then check the screws whether loose or not. If there is nothing wrong, you can start to run. To ensure the best molding effect, bulge pressure of hydraulic pump should be controlled within the limited scope.

When materials are fed into charcoal briquette machine, you should ensure the feeding work at even. According to the pressure in bin, you should adjust the work of vibrating feeder to the best. Charcoal briquetting machine is used for suppressing those mineral stone wastes or slags into briquettes. Since these briquettes can be directly used for metallurgical work, their value is very high.

In China, almost two thirds metallurgical plants use the coal briquettes as heat supply. Price is waiting for you on website!



High and New Industrial Zone, Kexue Revenue, High and New Technology Industrial Development Zone, Zhengzhou, China

Tel: 0086-0371-69606666

Email: sales@sinofote.com

Website: http://www.coal-briquettemachine.com